Walk-in Shower Conversions in Brighton, CO
Take out the tub you never use and put in a low or zero-step shower with a seat and grab bars. Typical price here: $10,100 – $19,000.
Walk-in Shower Conversions in Brighton, by the numbers
In Brighton, where the median house went up around 1998, a lot of hall and primary baths have a builder-grade tub that nobody uses. Pulling it for a walk-in shower with glass and a bench is a quicker, cheaper job than a full remodel.
Expect roughly $10,100 – $19,000 for a tiled walk-in shower in Brighton. Local labor rates and home values put the area about 19% above the US average.
A quick acrylic conversion with a low-threshold base costs about $5,300 – $10,700 here. Going fully curbless, with the floor lowered for zero entry, is closer to $15,500 – $29,700.
Timeline: An acrylic conversion takes 1 to 3 days. A tiled shower runs 1 to 2 weeks because the pan, waterproofing and grout each need time to cure. Curbless builds that lower the floor can take a bit longer.
Estimate your walk-in shower cost
Adjusted for labor and housing costs in Brighton.
Project level
Source: U.S. Census Bureau, American Community Survey 5-year estimates.
Walk-in Shower Conversions cost in Brighton
Installed price ranges adjusted for Brighton labor and housing costs. Your quote depends on size, condition and the products you choose.
Acrylic base + walls
Tub out, low-threshold shower pan, acrylic or solid-surface walls, new valve trim, curtain or basic door.
Tiled walk-in shower
Tub out, mortar or foam pan, full waterproofing, tile walls and floor, niche, glass door.
Curbless / barrier-free
Floor recessed for zero entry, linear drain, bench or fold-down seat, grab bars, frameless glass.
Cost breakdown
| Line item | Typical range |
|---|---|
| Tub removal and disposal | $500 – $1,400 |
| Drain relocation and new shower valve | $700 – $3,000 |
| Shower pan (prefab or mortar bed) | $600 – $3,000 |
| Waterproofing membrane | $500 – $1,800 |
| Walls: acrylic panels or tile, installed | $1,800 – $8,300 |
| Glass door or panel | $500 – $3,600 |
| Seat, grab bars, niche | $200 – $1,800 |
| Subfloor work for curbless entry | Often $0 – $4,800 |
| Permit | $100 – $700 |
Popular options
- Low threshold vs curbless. A low-threshold base has a 2 to 4 inch lip. Curbless is truly flat, which matters for walkers and wheelchairs, but it usually means lowering the floor.
- Seat and grab bars. A fold-down seat or a built-in bench plus two grab bars costs a few hundred dollars and is the most useful thing in the room as people get older. Blocking in the wall is cheapest to add now.
- Hand shower on a slide bar. Lets someone shower seated and doubles as an easy way to rinse the walls.
- Keep one tub in the house. If this is your only tub, think about resale. In most markets buyers with small kids want at least one bathtub somewhere in the house.
Free walk-in shower quote in Brighton
A licensed installer who works in Adams County will measure and price it. No obligation.
Choosing an installer in Brighton
Colorado has no statewide remodeling license; cities and counties license contractors and issue permits locally.
- Verify the license or registration on the state lookup and match the name on the estimate.
- Ask for a certificate of general liability insurance and workers' comp, sent directly from the insurer.
- Get a written, line-item estimate: demo, plumbing, waterproofing, tile, fixtures, permit.
- Ask who pulls the permit. It should be the contractor, in their name.
- Ask which waterproofing system they use behind tile and whether it carries a warranty.
- Keep the deposit modest and tie later payments to finished milestones, not dates.
- Get labor and product warranties in writing before work starts.
How it works
Measure and check the floor
The installer measures the alcove, finds the drain and joists, and checks for soft or rotted subfloor around the old tub.
Pick base, walls and glass
Prefab low-threshold base or tile, panel pattern or tile, and a door, fixed panel or curtain.
Tub out, drain moved
The tub comes out in pieces if it is cast iron. The drain is moved to the shower position and a new valve goes in at standing height.
Pan and waterproofing
The shower pan is set and sloped to the drain, then the walls are waterproofed. This is the step that decides if the shower leaks in five years.
Walls, glass, trim
Panels or tile go up, then the door, seat and grab bars. Silicone and grout cure before first use.
ZIP codes served
Nearby towns
Other towns in Colorado
More bathroom services in Brighton
Questions from Brighton homeowners
How much does a tub-to-shower conversion cost in Brighton?
Most Brighton homeowners pay $10,100 – $19,000 for a tiled walk-in shower. An acrylic shower conversion starts around $5,300, and a curbless barrier-free shower can reach $29,700. Local prices run about 19% above the US average.
Does a bathroom contractor in Brighton need a license?
Colorado has no statewide remodeling license; cities and counties license contractors and issue permits locally. Also check with the Adams County building department about permits for plumbing or electrical changes.
Which ZIP codes in Brighton are served?
Installers in our network cover 80601, 80602, 80603. If you live just outside them, call anyway. Most crews drive 20 to 40 miles for a job.
How long does it take?
An acrylic conversion is usually 1 to 3 days. A tiled shower takes 1 to 2 weeks with cure times for the pan, waterproofing and grout.
Does removing the tub hurt resale value?
Not if there is another tub in the house. If this is the only one, some buyers with young children will mind. In 55+ communities a walk-in shower is usually a selling point.
Is a walk-in shower or a walk-in tub better for seniors?
If the person can stand for a few minutes or is happy on a shower seat, a low or zero-step shower is cheaper, faster to use and easier to clean. A walk-in tub makes sense for people who want to soak or cannot stand at all.